Detector tester; Heat sensor tester, Smoke sensor tester and Flame sensor tester all in one device.
Fire detection sensors tester
Water mist system sensors tester
Multi Sensor Detector Tester is able to test smoke, heat and flame sensors. The tester has three pieces and telescopic bars. The lenght can be adjusted up to 2,50 meters.
RANGE OF ANALYSIS
– Flame detectors can be tested when the button is in the top position. The cover of the head must be dismantled, the led light on the top must be seen in working condition during the flame detector test.
– Smoke detectors can be tested when the button is in the middle position. The smoke must pop out from the smoke gun during the testing process.
– Heat detectors can be tested when the button is in the bottom position. The heat must pop out from the heat gun which is the same gun as the one used during the test.
Power supply voltage: DC7.4V, 2200MA / H
Charger output: DC8.4V, 500MA
Plus smoke test> 480
Heating test> 300
Flame test> 400
Connecting rod length: 0.5 m
Spectrum: infrared ≧ 850nm, ultraviolet ≦ 280nm and red ultraviolet broadband
Gun length: 1-2.5 m (can be extended )
Smoke source: Fog liquid
Applicable temperature: 5-40 ℃
Charging time:> 8 hours